Most of the seals we sell are pre taped.
How to install frameless shower door seal.
Inspect the bottom of the shower door to determine the plastic seal attachment method.
Mark each end of the seal at the points.
Snap the sweep onto the bottom of the door and slide into place.
It looks much like a shower curtain rod but is secured into the wall.
Measure the door height and cut the seal.
To install the glass door seal on the glass you need to measure the height and cut the seal accordingly.
The level of complexity and difficulty of a shower door installation depends largely on the type of door frameless custom heavy glass or standard sized framed and semi frameless products.
Seals typically slide into a channel at the bottom of the.
Attach the seal strip to the bottom of the door and cut it to the required length.
One side of your bottom sweep will have a drip edge or lip that side is installed facing the inside of the shower.
Place the glass clamp sweep into place on the door s bottom edge and secure it at the door clamp.
Most of our seals are pre taped.
The rail is attached to the door.
Install the support hardware on the bar matching the holes.
Measure your new seal against the edge of your shower door.
Mark the holes located in the glass panel onto the bar with a permanent marker.
Position the provided bottom seal against the lower edge of the door and position it so equal portions extend beyond the ends of the door.
Some important tips while installing our frameless shower door seals and sweeps.
Use the pfokus wipe and clean the door etch.
Remove the metal drip rail if necessary for plastic seal access.
Getting your basco shower door installed is one of the last pieces of the puzzle in your bathroom project.
You can also use the un taped seal or sweep and fix it using double sided tape.
How to replace the plastic strip on a shower door.
Peel back the tape on the back of the seal and push the seal on the door starting from the bottom to the top.
Put the finishing touch on your shower door installation.
Place end caps on the tops of the wall channels.