You are going to have to remove the pocket door to get the hanger out where you can work on it.
How to get a sliding door back on track.
Turn each screw counterclockwise to raise the wheels and lower the door so that you can lift the door up and out of the track.
How to get old bypass closet doors back on track occasionally we ve had a door come off the overhead track and experienced a great deal of frustration getting the door back up and rolling smoothly.
Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track.
Reinstall the sliding panel by inserting the top of the panel into the top track and lifting the door onto the track.
Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.
If you don t lower the wheels the door will fall out of the frame when you try to open or close it.
Moving the door when the back side is sliding on the ground is a little difficult.
This is a demonstration of how to adjust a sliding screen door so it can be put back on track.
It is best to apply wd 40 or silicone lubricant to the track a.
Remove the floor keeper from your sliding door using a screwdriver.
Check to ensure that the bottom of the door frame is not dragging on the track.
After you lower the door lower the wheels by turning each screw clockwise to secure the door in the frame.
With the door set aside vacuum up any debris and wipe the track clean.
When the back pocket door hanger is off the track it is a bit more of a problem.
Raise the wheel by turning the adjustment screw counterclockwise.
Release the door and let it swing gently back to the vertical position.
Lower the door when both wheels are on the track.
First locate the adjustment screws along the bottom of the outside face of the door frame shown or on the door s inside edge.