Place one screw at the top of the skull and drill slowly to prevent cracking and splitting the skull.
How to hang deer skull on the wall without nails.
By hand bend the corner brace about 10 30 degrees to get the desired angle.
Just make sure that the clothing.
You could use a ring from a key ring or even.
Drill carefully into the skull at those points with a power drill.
Insert your bolt through the panel place the wing on the bolt and insert that into the hole in the back of the skull.
Feb 20 2014 8.
A mount will hang much more secure when it is tight to the wall too and they also look better too.
In this case you use a skull hanger to position the skull to the angle of your liking.
Run a 3 inch screw horizontally at the ceiling and attach your rope wire there.
Trophy specialist apr 21 2011 apr 21 2011 6.
Use screws measuring approximately two inches longer than the depth of the wooden plague.
Use locktight on the two nuts to keep the bolt in place and you can paint them a flat black to be less conspicuous if desired.
I prefer level right hangers and drill out the plywood behind the hanger so the scew head can be any distance from the wall and still allow the mount to hang tight against the wall.
Hang your deer skull with an adjustable skull hanging bracket stepping it up a level displaying a european deer mount on the wall gets a little more interesting when you have freedom of the angle you display the skull at.
All you need is 1 2 5 x 5 8 corner brace 2 1 4 20 hex jam nut and 1 1 4 x 1 5 carriage bolt.
You ll need to attach a decorative rope wire to the rafter cap on the wall.
The fourth and final step to a european mount is to actually mount display the deer skull.
Mark the placement for two small holes on the back of the steer skull directly behind the eye sockets.
Then tighten down the bolt.
One method i have seen taxidermists use on rugs that are ment to hang on the wall sew on small rings to each point where it would need to be supported.
Drill a small hole into your panel so the skull would be centered on the panel.
Works really good on all kind of skulls.
I am using a standard utility or clothing hook to mount the skull.
My wife remembered that our son had found a cow sku.
Drive a minimum of two drywall screws through the wooden plaque and into the back of the deer skull.