The ground floor is partitioned in two by a dividing wall and french doors.
How to flatten concrete wall.
Sand any particularly bad areas of concrete with rough grit sandpaper.
Drill the hole at least 1 4 inch deeper than the length of the lower portion and vacuum or blow out the hole.
A hammer drive anchor requires only a small pilot hole.
Immediately level and prepare further using a bull float.
Spread the mortar with a notched trowel allowing the notches to lightly scrape the concrete below.
Step 3 mix the plaster mix your plaster according to the manufacturer s instructions preferably in an area away from drying winds and direct sun.
Apply a coat of the mixture to your concrete wall before plastering it and allow it to dry for a day.
Do not try to make the wall level.
Trowel a 3 8 inch.
The one shown requires only a 1 4 inch hole.
How to smooth a concrete wall finish step 1.
The bull float should have rounded ends not flat or straight ends.
Spread a thin coating of mortar to the underside of tiles before setting them in place on the.
Avoid using a square float as it.
Roll liquid concrete bonding agent over the surface of the wall in fairly straight lines using a short napped.
The bull float is a flat long handled tool used to flatten minor ridges and holes as well as embed aggregate particles further into the concrete bringing the smoother cream consistency concrete to the surface for better finishing.
For a flat finish apply a layer of dash that is almost liquid in consistency.