Moving the door when the back side is sliding on the ground is a little difficult.
How to fix a off rail hanging closet sliding door.
If the rollers are damaged install replacement rollers available at home centers.
To take the door out you ll lift it out from the bottom track.
The first thing to check is what type of rail system your sliding closet door uses in order for it to slide.
Lubricate the rollers but not the track because lubricant will act as a magnet for dust.
If you have a sliding closet door that glides on a bottom track clean the track with a damp cloth to ensure smooth gliding.
Unscrew the brackets on the top of your doors to loosen them.
Maybe its your sliding track maybe slider wheels.
See if the screws holding the guides down need tightening to be more secure.
Grab the door from both sides and lift it off the track.
Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.
The home mender dustin luby shows us how to fix that ancient pesky problem my slider doors wont slide.
Reinstalling sliding bypass doors the doors are usually interchangeable but you will want to start with the rear track.
Try holding your foot against the bottom of the door and pull gently on the top of the door to lift the back side.
The first thing to check is what type of rail system your sliding closet door uses in order for it to slide.
Use an aerosol lubricant to lubricate all the door rollers.
See if the screws holding the guides down need tightening to be more secure.
You are going to have to remove the pocket door to get the hanger out where you can work on it.
To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks.
To make space to maneuver it you will loosen the brackets on the back.
Whether your door is unhinged from the top or bottom angle it at 15 to 30 degrees away from the unhinged track and slowly pull it outwards from the closet.
Work the door slowly into the opening in this manner.
Use the philips or flathead screwdriver to loosen each screw on the brackets at the top of your door.
If your doors hang from a top rail and do not have a track on the floor then you need to either replace or tighten down the floor guides.
If a roller is stuck unscrew and remove it.
Remove a door by lifting and tilting the bottom out.