Piece together the new door lock cylinder like the old one by putting the rubber gasket on the part of the cylinder that fit on the outside of the car door.
How to change door lock cylinder.
The one presented here is a.
Prop open the door as you change the lock.
Unscrew the main screw red dot place the key inside the cylinder and turn it to the left or right to make sure that the carrier is parallel with the cylinder.
Remove the plug by pushing the plug follower supplied in the kit through the cylinder.
Turn the key a quarter of the way.
Orient the turn assembly plate such that its top side is at the top.
Remove the trim on door handles by unscrewing it around the base of the door handle.
Alternatively if you are.
Changing an interchangeable lock cylinder 1.
Remove the faceplates for a stand alone lock cylinder without a door handle via the screws.
Insert the old key and turn it either to the left or right.
Push the new small bracket onto the cylinder to hold the gasket in place.
At this point the square tab on the spindle is aligned with the square.
Remove the flat screw under the latch.
Turn the screw under the door latch.
The top of the cylinder contains pins and springs which keep pressure on the keyed pins.
With a barrel lock it s the cylinder that allows the locking and unlocking of a door.
Test the new door lock cylinder by locking and unlocking the door using the new cylinder.
How to change the lock cylinder in an entry door 1.
Use the flat head screwdriver to turn the spindle in the center of the door lock cylinder counterclockwise until it stops.
On the opposite side insert the bar into the channel in the back of the turn assembly plate.
Pull on the.
Put the complete lock assembly into the hole in the door and align with the cylinder slot.
Remove the old cylinder from your door.
Position the lock mechanism such that the keyhole is vertically aligned.
Insert the key into the keyhole and turn it slightly so that it s in the open.
Insert the new lock assembly.
Locate the screws on the.
Place the big bracket that holds the door lock cylinder tight to the inside of the door.
There are several types of cylinder locks.
Push the new small bracket on the cylinder to hold the gasket in place.