The photo eye sensor for a garage door opener is typically placed approximately two inches off of the ground.
How to bypass safety beam on genie garage door opener.
Since most photo eye sensors are placed at that two inch height most people know you can simply step high above the infrared light to bypass the system.
If anything is blocking the light the door won t close.
Cut the wires about 1 inch 2 5 cm from the safety sensor.
If one of the photo eye sensors are malfunctioning it will begin to blink rapidly.
The genie pro screw drive garage door opener has a transmitting led on on end of the door and a reciever on the other.
Press the garage door opener wall button to fully open the garage door.
This safety feature was made standard in the early 1990s to avoid unnecessary injuries.
Final takeaway bypass garage door sensors.
It s very easy to bypass garage door sensors just follow these simple steps.
If done correctly you ll have disconnected your safety sensors from your garage door.
Reattach the cut wires to the new sensors.
The safest way to bypass a garage door sensor is to disconnect the garage door from the opener.
Garage door sensors are safety mechanisms that won t allow the door to close if something is blocking their beam of light.
Step 2 pull the emergency release cord to disconnect the garage door from the opener.
Sunlight seems to kill the reception and even if it s lined up it won t recieve the signal and it won t close.