Our goal in this article is to explain.
How to attach metal roofing.
Bend panel edge we will prepare the end of this panel by cutting up one inch on either side folding under and.
Use your neoprene washer head screws to secure the metal to the sheathing.
And for any exposed fasteners try to avoid over tightening them.
Corrugated metal roof installation instructions step 1.
For exposed fasteners avoid over tightening the fastener.
Place the first screw.
Hidden fastener installation step 1.
Install offset cleat install the offset cleat along the eave and then you are ready to install the metal.
Install the roofing screws vertically along each rib in the panel.
Buy the metal panels.
Be sure the larger edge is laid so that the small edge of the next panel will overlap it.
You will use metal roofing screws to secure the metal panels to the sheathing.
Screws are much stronger than nails in terms of pull out strength they don t back out as readily as nails and it s possible to get a better seal with screws than nails.
Space the screws about 12 in 30 cm apart.
Without getting up on the roof itself you can get the measurements simply by measuring the.
Try to space the screws about 12 inches apart down the entire piece of metal.
Moreover try to ensure that the screws are all aligned evenly.
Make sure that the screws are all aligned evenly as you will be able to see them from the ground if they are.
Our company definitely recommends screws over nails for attaching metal roofing to the purlins.
The correct method of tightening the screw do not install the screws sideways remove metal shavings pre drilling screw holes using the correct tools chalk lines.