How To Apply Stucco To Concrete Wall

Stucco a masonry or concrete wall 1.

How to apply stucco to concrete wall.

How to apply stucco to concrete step 1. Load stucco on a hawk and then take it on trowel for application. Apply the first coat. Apply the stucco by swiping it onto the lath in a layer that s approximately 3 8 inch thick.

Allow it to dry completely. Wet the wall right before you apply the first coat of plaster preferably with a fog spray. To apply stucco to your existing brick block or concrete wall first brush a concrete bonding agent onto the wall. Mix the scratch coat.

Make it as thick as you can get it on the wall without it sliding off. Apply the stucco to the wall with a trowel to a thickness of 1 8 inch. Use a masonry trowel to apply the mud in overlapping arcs to the wall. Work in small batches so that it doesn t have a chance to dry out and harden.

Work from the bottom of the wall up and apply at a thickness of about 3 8 inch over the entire area. Mix finish coat stucco with water to the same consistency as the base coat adding stucco colorant as needed to give the material the desired hue. Mix the stucco with water according to the packaging instructions. Get started with the application over the cinder wall using a trowel.

Mix your stucco according to the manufacturer s instructions. Make sure you apply the mix carefully covering entire surface with a thick coat. After the mortar. Use long strokes knife swaths and other techniques to give the stucco the desire texture.

You may apply stucco directly over these rigid solid surfaces but only if the surface. Flatten the final texture with a trowel. Use firm trowel pressure to force the stucco into the lath. Prepare the wall s surface.

Applying stucco over concrete or masonry 1. They vary in size and type and it is based on your personal preference as to which exact trowel you use the new layer should be. Apply a coat of concrete bonding agent to the concrete surface using a paintbrush. Apply the new layer of stucco with your chosen flat trowel.

Prep the wall surface by spraying the block with water to prevent the stucco from drying too quickly. Spread enough to cover an area about the size of your arm span. Then trowel the surface to your preferred texture. Once the entire wall is covered drag the scratcher across it in horizontal lines.

Use required pressure so as to press the mix into the wall as you go on applying it. Apply the base coat stucco using a square trowel held at a 45 degree angle.