How To Adjust Fire Door Hinges

Close the door completely.

How to adjust fire door hinges.

Place the locking pin nearer to the door and release the spring pressure. Find the hole beside the locking pin on the hinge s spring which is usually either at the top of bottom of the hinge s housing. If the top corner of your door is catching on the frame you ll need to adjust the hinges 1 x research source another step 2 tighten the screws on the door hinges with a screwdriver. This hole is normally located either at the top or the bottom of the hinge s housing.

I ll bet that you never knew you could adjust a self closing door hing. Check the top of the hinge to see if it has a screw which protects. Insert a nail set on a hole located beside the locking pin of the hinge adjustment spring. Over time the hinges on a door can loosen and cause the door to sag downward.

Remove the locking pin by rotating the adjustment in the direction of the jamb. If it does not fully close the hinge will need tightening. Stand on the side of the door with the hinges and shut the door until it latches. If your hinge has a tension pin inserted into the side of the hinge you need to pull the pin from the hinge with needle nose.

Test the door close rate. With a small screwdriver you can adjust the door left and right back and forth and up and down as well. Changing tension with a hex wrench 1. Insert a hex wrench into the.

Tightening the door. Rotate the wrench until the next hole comes into view and install the pin. Step 1 examine the top corner of your door to see if it s catching on the frame. Place the hex wrench into the socket at the top of the spring hinge and turn in either direction to release tension on the pin.

You may need to remove the soft closer or a cover cap if there is one to expose the adjustment screw heads. Tighten or loosen in small steps. Rotate the locking pin to remove and replace the pin one hole further away from the door. When this happens the top corner of the door catches on the door frame and prevents the door from closing properly.

Adjusting a spring loaded hinge must be done with the door closed. Remove the pin with a pliers.