You either move the hook holding the.
How to adjust extension spring on garage door.
With the door propped open take the s hook out of the support and tighten or loosen the cable as needed.
Change the length of.
For extension springs this is in the up position.
Next get hold of one of the tension rods and push it into the first notch.
Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension.
It should be placed on the left hand side of the torsion spring and placed away from the garage door s center.
To keep the door from falling it must be clamped to hold it in place.
To be able to adjust the springs the door must be in a position that release the tension on the springs.
Take note of the notches and screws that hold the torsion spring in place.
This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.
The cable is attached to the door and runs to an s hook that attaches to the track support.
There are two ways you can change the tension on the springs.
This video is for guidance only we will gladly undertake garage door repairs in manchester and stockport for you call us today 01663 749007 or visit www hi.
Raise the door and release the garage door opener.
You must release the tension on the garage door springs before attempting adjustment or replacement.
How to adjust extension springs secure the door in place.
To make fine adjustments try adjusting the lifting cable instead of the spring.