How to replace wall switch to a garage door opener.
How does a garage door switch work.
In turn the electric motor engages a track and pulley system which then opens or closes your garage door.
The standard sensor works the same as on any other door.
I can open close the door turn on off the opener light and lock the remote controls.
The infra red sensors that facilitate your garage door opening system are placed on either side of your garage door doors and they stand approximately six inches off of the ground.
There are two ways to detect a garage door opening.
The unit remembers what direction it went the time before.
An inverter switches household ac power to dc which is also used to charge a battery backup.
These functions are controlled by adding a resistance to the wired pair.
When the garage door is raised it breaks the circuit and sets off the alarm.
Loosen the two terminal.
Locate the bell wire that connects the wall switch to the garage door opener.
The two pieces are installed next to each other one on the door and one on the wall right next to the door.
Place a stepladder beneath the garage door opener and unplug the power to the unit.
Each control has a different resistance.
To allow smaller more efficient motors most garage door operators use dc current.
The open close is just a short.
If the garage door is hard wired into the electrical.