How to replace nissan quest blend door actuator the easiest way to fix.
How fix slide rigth slider door nissan quest 2005.
After getting a battery jump the rear pass.
The right sliding automatic door of my 2005 nissan quest will not open completely when the button is pressed.
I recently purchased a 07 quest with power sliding doors.
If the sliding door on your van is hard to open and close or if it feels like the door of your van is stuck when you open and close it you can fix the stuc.
It will answered by a verified nissan mechanic we use cookies to give you the best possible experience on our website.
Tims auto repair.
Disconnect the sliding door rear latch cable from the latch remote control.
It must be repeated if needed on a second door.
You ll need to lift the door panel upwards in order to get it off the window ledge.
After turning of the auto door closing and doing it manually for a few weeks it seems that it works more often than it used to.
Turn the power off to the door lube the pivot with penetrating oil and open and close the door manually several times.
Open the sliding door.
Door doesn t close fully anymore leaving the warning light etc.
They bind up and cause the door to reverse.
Sliding passenger door does not close properly when using the automatic door closing.
This feature is not available right now.
If necessary transfer parts to the new sliding door latch remote control.
Turn the ignition key on.
Mercury villager nissan quest sliding door handle.
2004 2007 quest v42 if you confirm you need to replace the sliding door motor or cable closure assembly for any reason.
Sliding door motor and cable assembly replacement applied vehicles.
I have tried disconnecting the battery again and the initialization sequence from the manual but no.
Sliding door initialization procdure note.
Remove the 4 sliding door front latch bolts.
Within 3 seconds after step 3 press the sliding door b pillar switch lh or rh.
The following procedure is for one sliding door.
Check the pivot at the rear of the door for rust.
Remove the sliding door latch remote control.
Remove the sliding door rear latch cable adjusting bracket from the latch remote control.
Turn the automatic door main switch off.
On the inside trim you can remove screws that are by the door handle arm rest under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don t want to break them.
Please try again later.
I then have to step out and manually push the door further to latch.