How To Install Tarco Roll Roofing

4 unroll enough roofing to span.

How to install tarco roll roofing.

Application unroll the fiberglass mineral surfaced roll and allow it to relax in direct sunlight. Clean the roof with a broom to remove any debris. Extend the front edge of the drip edge so it runs off the roof and into the. Cut a hole in the roll roofing and slip it over as well.

Bought this roll from home depot. Snap a chalk line that is uniformly 35 inches from the edge of the roof. The piece should overlap the lower course by at least 4 inches. Install a full width roll in a horizontal manner such that the edges are flush with eaves and rakes.

It was pretty easy to install and took about an hour to do by myself including setup and tear. To seal a plumbing vent spread roofing cement around the pipe. This is not a how to video. Cut the roll into manageable lengths typically 12 to 18 feet before installation.

Measure 35 inches from the outside edge of the drip edge onto the roof with a tape measure. Attach drip edge along the edge of the roof with roofing cement.