Then take another tile and peel off the paper.
How to install plastic walls over old tiles on walls.
Remove the existing tiles and re tile.
Apply a bead of sealant onto the panel keeping it about 1 inch in from the foam tape around the perimeter.
Tiles are one the most common forms of wall covering but can look dated after a while and grout has a nasty habit of turning grubby with time and can even start to harbour mould.
A bath wall kit is otherwise known as a bath surround or a bath liner.
Apply strong adhesive to the tile and the wall.
Rub your hand across the panel up and down to press it firmly against the tile.
Can this be done or do i need to remove the old tile first.
Layer newspaper on the floor across the bottom of the tiled wall.
Remove the tile and prepare the wall according to the corresponding instructions above or tile over the existing tile.
I was hopeing to just go over it with one of those tub wall kits.
In our case we used beadboard panels from georgia pacific the brand name is plybead.
Repair any loose or cracked tiles.
Peel the paper backing off of the foam tape on the back of the panel and position the panel over the tile.
Paint the existing tiles.
The kits are available at many home and hardware stores for a do it yourself project and at commercial companies that sell and install the kit.
I want to remodel our bathroom and the house came with some ugly pink and green tile arround the tub.
Tile over the existing tiles.
Press it firmly up against the wall and make sure that you hold it for a few seconds to allow the adhesive to stick to the wall.
To do so make sure all of the tiles are intact and secure.
A good option to address the old plastic wall tile is to cover it with decorative panels.
Scrub the wall tiles with diluted degreasing cleaner and a nylon scrub brush.
Leave at least 1 4 inch edge around the installation area.
This is an older house with plaster walls and i didnt really want to deal with replastering if i dont have to.
The panels are 3 8 thick and installed easily by using a construction adhesive along with some finish nails to hold in place until the adhesive set.
In this situation the options are.
Remove the tiles and panel the walls.
If you re working with an existing tile wall you have two choices.
Take the first tile and press it onto the wall in the area where you made your marks.
Not necessarily panelling but panels that are current and attractive.
If existing tiles are beyond repair remove the tile and install a piece of wallboard in its place.
They are one piece plastic or acrylic units that slide over the top of an existing bathtub or shower to give it a like new appearance.
Make sure that the holes line up with the faucet bars and shower head prior to pressing down on the surround.