Remove wires from existing wall console.
How to install garage door wall console.
Installing replacement wall console disconnect power to powerhead.
This series two wall console is very easy to install with only 2 mounting screws and two wires that attach to the back of the console compatibility.
This diy repair guide explains how to replace the wall control for a garage door opener.
Genuine genie multi function wired wall console for use with garage door openers that have series ii electronics.
The wireless wall console can be programmed in a similar way that any other genie intellicode remote is programmed by pressing the program button on the opener for approximately 2 seconds then pressing the large door button on the console 3 4 times until the door moves.
This video from sears partsdirect shows how to replace wall control on a garage door opener.
Wall console lock mode allows keypad and remotes to be locked out for security at night or while on vacation.
I then connected the 2 wires to the new wall console as they were on the old one.
The wall control is mounted inside the garage next to the door.
Open close lock and light.
Turn off the electrical power to the garage by shutting off the circuit breaker at the main panel.
Choose an area for the console.
Back lit panel makes it easy to locate.
Measure 5 feet from the floor up the.
Split and strip ends of wire if required fig.
I turned off the power to the garage door from the electrical panel for the house.
How to install a garage door control console 1.
I took out the 2 screws that held the old console to the wall.
Located on the garage wall by the door to the house the control opens and closes the garage door and turns the garage light on.
If nothing happens when you push the control button the control is most likely broken.
Verify height at least 5 ft.
Remove existing wall console from the wall by removing mounting screws.
Mount wall console to wall using screws provided.
It has 3 function buttons.