How To Hook Up Garage Door Cables

Step 3 attach the cables.

How to hook up garage door cables.

Then reattach the wire to the frame by means of the hook. Put the cable back on the pulley if it has come off. Open up the door and use a vice grip just below the bottom garage door roller on both sides to hold the door. Step 1 preparation.

How to replace your garage door cables. Step 2 wrap the cables. Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums. Use the pliers to loosen the bracket holding the wire to the hook that s attached to the frame pulling the cable wiring through the bracket in order to tighten it.

If a cable comes completely off of the pulley use your hands to. At the top left and right corners of the garage door frame are. Wind the cable around the pulley if it s loose. Garage door cables can be purchased here.

Lower the door and use. How to install garage door cables. This should be a red rope with handle that is located near. Pull the cable as tight as possible before tightening the setscrews.

Unplug and disengage the garage door opener by pulling on the emergency release handle. Rotate the drum to wind the cable into the winding grooves. Positioning the cables correctly 1.