3 using double sided tape to hang string lights on a stucco wall a.
How to hang on stucco wall.
Using wire hangers 1.
Some of the anchors will require you to twist them into the wall which makes for a better anchoring point.
Tap it flush with the wall using a rubber mallet if it doesn t go in easily.
Puncture the wall with the sharp and.
Use tri sodium phosphate tsp or rubbing alcohol for the best results.
This bit will drill through the stucco about.
The tape helps.
How to hang on stucco with no damage.
If you plan to hang a frame with wire backing make sure you.
There are several brands of lightweight wire hangers that can be installed.
If you re mounting outside art or decor flat on the wall wipe the.
Stop when the screw head are about 1 4 inch from the.
Clean the area where you ll hang your outdoor art with tsp or rubbing alcohol.
Mark where you want to place your hook with a pencil.
Use a stud finder to locate the studs behind the stucco and mark them with a small pencil mark.
Apply a small amount to a dry microfiber cloth and wipe down the surface of your stucco wall.
Hold the decorative item against the wall and use the pencil to trace inside the holes for the mounting screws.
Drill through the center of each traced hole with the masonry bit.
Gently tap the anchors into the stucco wall using a hammer until they are flush with the wall.
Use wire hangers to hang heavy frames.
Peel off the back and press your outdoor wall art firmly.
How to hang something from an outside stucco wall step 1.
The lower anchor in the picture illustrates a properly installed anchor and how it should sit on the wall.
Drive the masonry screws into the anchors with a power screwdriver.