How To Hang A New Door On Existing Hinges

Cut the hinge mortises with a hammer and inch wide wood chisel.

How to hang a new door on existing hinges.

How to hang a door in an existing jamb. Remove knob and lock set. Mount the hinges on the new door and hang the door. Working from the hinge side or rear of the door take out the door knob and existing lock set.

If you are hanging a slab door to replace an existing door and you still have the original door you can measure your new door slab to fit the frame by aligning it with the old door. Remove door from hinge knuckles. Drill a hole through the. Align the door with the existing latch plate on the jamb and mark a spot for a knob.

Once the hinges have been installed remove the pin from the new hinges and fit the door into the door frame. Set the door on its side with the inside edge of the door where the hinges will go facing up against a stable. To do this place both doors next to each other on the thin long sides with the hinges on the old door facing up. Clamp a straightedge to the new door and score the cut line with a sharp utility knife.

If the old door was trimmed at the bottom and you were happy with the gap at the floor cut the new door to match. If your frame already has hinge mortises stand or lay the door inside the frame as if it. Trim door to correct size. Follow the instructions and get your job done with ease.

Transfer the hinge locations from the door frame. Mortise the hinge openings using a chisel and utility knife photo 4. Make sure it s flush. Once you ve finished mortising the hinges set the door upright and bore the lockset holes.

This article gives you the best instructions on how to hang a door on hinges. Set old door on top of new door and transfer the hinge mortise locations to the new door using a combination square. Use a utility knife to score the outline of the new hinges onto the edge of the door. Set the door on the hinges and fasten the door to the hinges with the hinge pins.

Once the hinges match up insert the pins. How to put hinges on door blanks. See where the old hinge was notched out on the door.