How To Hang 4 X 8 Heavy Picture On Wall

Look for hanger packs that contain assorted hardware for different uses.

How to hang 4 x 8 heavy picture on wall.

Once it s secure hang your picture on the hook. You put the hook and anchor together before screwing it into the wall. For heavy pictures secure the hangers to wall studs if you can. To start hold the mirror in the spot you want it then trace around the top and bottom edges with a pencil.

Find a wall stud using a stud finder or by gently tapping the wall until you hear a solid rather than a hollow sound. Here s a better way to hang pictures and other light items on drywall. Remove the back liner from the adhesive strip and apply it directly to the wall where you want to hang your picture. You can use a drill or screwdriver to fasten it to the wall.

Place a scrap piece of wood that is approximately half as long as the mirror is wide underneath the hanging wire on back of the frame. Remove the front liner from the strip and firmly press the utility hook against the surface. If it goes in it s drywall. Use a hammer to drive the stem of a rivet down and into the wall.

The rivet head won t slide into the wall when you hang the picture. Put a nut washer and toggle nut on the bolt. When a wall stud isn t available where you want to hang a heavy picture a toggle bolt provides the most holding power. Studs behind drywall are located about 16 inches apart.

The most secure way to hang a heavy mirror or painting on a wall is to drive a long screw directly into a wall stud. Measure from the top of the picture to the hanging hardware. For heavier pictures it is best to hang your picture on a stud. Hold it steady and in place for 30 to 40 seconds.

Take your picture down from the wall and flip it over so that the back is facing upwards. Rivets at the hardware store for less than 5. If the picture is wider than the distance between two studs use a level and two screws to place the piece of wood into the wall. I ve used both a drill and a screwdriver when putting these into the wall and either way works just fine.

Hang your picture on a stud. Then just hang your art on it. The anchors and hooks are separate in the package. Masonry walls require a drill with a masonry bit and masonry screws.

To install a toggle bolt. It is best to hang the picture on a stud so that the wall can accommodate for the weight of the frame. Lay the mirror aside then install the clips two along the top and two at the bottom. Mark the location of the top edge and the center of the frame.

Hook a measuring tape onto the hanging wire and pull it taut so the wire stretches up toward the top of the frame. Set the mirror down. Not sure if you have drywall or plaster. Push a pin in the wall.

Hold the mirror against the wall at the desired position.