Trim frp panels to fit step 3.
How to glue plywood wall panels.
Measure walls step 2.
Allow the glue to.
Cut wood panels 3 4 inch shorter than the wall s height to hold the bottom edge off the floor.
Small dollops of hot glue.
Squeeze the handle on the caulking gun so panel adhesive comes out.
3 following manufacturer s instructions apply panel adhesive to wall studs or furring strips.
How to glue paneling to walls 1.
Do not apply adhesive beyond area to be covered by panel.
Starting in the corner run a small bead of adhesive along the studs furring or if you are installing on solid wall apply adhesive in a grid pattern.
General purpose construction adhesive step 1.
This protects the panel from wicking moisture or water from the floor.
Smear a quarter size amount of the panel adhesive onto the wall.
Insert the tube in the caulking gun then cut the tip of the tube at an angle with scissors or a sharp utility knife.
Cut any fixture openings step 4.
Repeat every 10 inches 25 4 cm up down and across the section of the wall where the first plywood panel will go.
Only apply the panel adhesive to one section of the wall.
Install the corner moulding and panel step 5.