Screws with oversized holes can also be tightened at least temporarily by inserting several pieces of toothpicks or some steel wool into the hole.
How to fix steel french doors that stick.
If you break off a screw head or strip it use an inexpensive device called a screw extractor to remove it.
If not remove the door from its hinges and lay it flat on the floor to sand.
Use a sharp wood chisel or knife to carefully peel off defects in the finish that could cause sticking.
Tighten the screws that go into the door and the screws that go into the door frame.
Before doing so mark the spot with a pencil on either end where the door needs to be sanded.
Lumps or thick drips in paint or varnish on the edges can make a door stick.
In most cases the problem is now fixed.
Screws magically work themselves loose over the years.
Fixing french doors is not rocket science.
This can be done while the door is in place if you have access to the necessary spots.
Make sure that closes properly.
To repair a stripped screw hole under the hinge leaf tom plugs the hole and gives the screw something new to bite into.
For your french doors that won t close the secret to repairing french doors is to align french doors first by securing all the french door hinges to the.
He taps in the plug with his hammer and glue oozes out of the hole.
Do not over tighten the screws or you may strip break them.
Set up a power or cordless drill with a screw tip attachment.
If your door rubs near the top or drags on the floor use a screwdriver not a drill to tighten the screws.
Smooth away any spots that stick with a sanding block.
You know where you have sort of the overlap the astrical moulding.
With a drill you re more likely to over tighten the screw and strip the screw holes or chew up the screwheads.
Tighten the screws in the hinges at the edges of the doors and at the faces of the doorjambs at each side of the opening.
You close the door with sort of the jamb side on it.
You do this one door at a time.
Then bring the other door into it.
If the french doors have dropped due to loose screws in the hinges attempt to tighten them before you test the doors again.
If this is the case you may need to remove the entire doors so you can renew the holes.