How To Fix A Punched Door Lock

The repair is quick and easy.

How to fix a punched door lock.

Leah demostrates how to repair a hole in a hollow core interior door using low pressure foam insulation and plastic wood putty. My daughter has a 2000 excursion and some wonderful person punched the passenger door lock the door will not lock or unlock now. The threaded hole in the back brace is not centered on the strip. It is held in by a spring clip and can only go in one way.

But worse yet to get in they punched the drivers side door lock all the way in. Insert the punchplug into the lock holder black side down. You just have to buy a new door handle assembly and you ll probably be able to use the old lock. Tighten the hinge screws and then try adjusting the strike plate by loosening its screws and shifting it slightly.

If not you ll have to buy a replacment for that as well. In some instances the lock is still good as well as the handle and all you have to do is pull your door panel and snap the lock cylinder back in place. The lock usually comes un coded not keyed so you will have to have it coded to your existing key. Whats the best way to fix it.

1a auto shows you how to repair install fix change or replace a broken damaged worn or faulty ignition lock key cylinder. Could i just use jb weld and just have that cylinder stuck in place forever then. My passenger door lock was punched how do i fix it. This video is applicable to th.

Wash the excess glue off with hot water the next day and paint any scratches. I recommend getting a set of jimmy jammers to prevent it from happening again i ended up putting them in both the front and rear doors as you can pop the door handles out if even if there is no keyhole. Repairs range from making minor latch adjustments to repositioning the door. Do i have to replace the acuator and e.

At this time if the back of your handle has been broken see also step 9 below 5. Insert the back brace strip through the slots where the lock retaining clip was located. Remove the door hinge pins and pull back the press board and pour the glue around inside and use a putty knife or a piece of cardboard to get it on the edges.