Fill in the dent.
How to fix a dent in aluminum garage door.
Put a strip of aluminum foil over the dent.
Prime the patch and repaint the entire door to hide all evidence of patching.
Fix a door that won t close.
Lay the piece of aluminum foil flat and cover the dent.
It is vital that the entire area is heated.
Fill in the dent.
If the dent isn t too bad you could fill it in to make it look smooth again.
Apply both fillers in the same manner.
Fill a bucket with water and add 1 teaspoon of dish soap.
Use the sponge with the water and detergent to wash the dented area of the door thoroughly.
Place a square of wood on the distending side of the dent if conceivable.
Your next step will be cleaning the problematic area with warm water and a mild detergent such as dish soap.
Below are ways to fix a dented garage door panel.
Steps to repairing garage door dents.
A secret tip to fix a dented aluminum garage door.
Use the heat source so it evenly heats up the foil.
Fill a bucket.
You ll need to sand the dented area down and then use a mixture of auto body filler with hardener to fill in the gap.
Make sure you use a consistent motion so that the flame hits the aluminum foil wherever the stubborn dent is.
Fill the bucket with water and add some dishwashing detergent.
Taking the lighter move it over the area of the dent making sure you cover the entire area with the flame with a consistent motion for one minute.
Take a sheet of foil which covers an area.
Dry the washed area of the door.
Pick up your lighter and move the lit flame back and forth over the dent for 60 seconds.
Tap the square with an elastic hammer to straighten out the dent.
How to repair garage door dents.
Finish off with paint.
Keep at it and this should hammer the dent out.
Prepare the surface of the door patch the dent and sand it smooth as shown in photos 1 3 deep dents may require a second coat after the first one dries.
Wash the dented area of the.
After a minute remove the foil and spray the dent with the compressed air upside down for about 30 seconds.
Clean the problem area.
Lay the foil flush against the dent so it is completely covered.
Swirl the water and dish soap with a sponge to mix.
Use one hand to hold the foil in place to keep it in place.
Unroll and cut a piece of aluminum foil from the roll that is long enough to completely cover the dent in.