Create the spindle holes using a drill being careful to keep the drill parallel with the floor.
How to fit a new door handle and lock.
Drill the latch hole in door.
Before you can fit a door handle to a new door you will first need to mark regions to be drilled and.
If your new door handle attaches to the door at a point below the lower borehole like ours you may need to drill another hole to accommodate.
This video is about how to fit a door latch and door handle in an interior door.
Tools needed for this job.
Insert the new bolt into the opening on the edge of the door and fasten it to the door with the provided screws.
Mark the latch lock position.
Install the inside handle.
Marking the door handle positions.
Tape measure pencil flat drill bit for wo.
Drill these two spindle holes on both the front and back of the door.
Line up the spindle on the back of the handle with the slot in the latch sliding any mechanisms up or down as needed to fit the handle onto the door.
Drill holes in the door.
Insert the exterior part of the lock into the door by feeding the long metal piece through the opening in the center of the bolt.