Holding the level and speed square level locate the measurement on the speed square where it meets the bottom edge of the rafter to find the angle of the roof in degrees.
How to find the angle of a roof with a speed square.
Place the pivot point on the square against the bottom of the rafter and align the 90 degree angle side of the square with the pencil mark.
Step 2 find an angle.
With a torpedo level and a speed square you can pretty accurately gauge the pitch of any roof with a gable end photo 1.
The hash marks with corresponding numbers between 1 and 30 refer to the roof s rise angle.
Use a spirit level to mark a straight vertical line across the rafter.
As an example pivot the speed square until the numeral 30 aligns with the opposite edge of the piece of material.
If not the 0 degree mark should be at the opposite.
Follow the bottom edge of the rafter to where it meets the common pitch reading.
Set the level on the edge of the speed square as shown below then place the heel of the speed square on a rafter or gable edge of the roof.
It s often marked right on the tool.
Place the pivot point against the shingles.
Hold the pivot point against the board and move the square until your desired angle lines up with the edge of the board.
Read the pitch on the side of the rafter square.
Line up the pivot point on the bottom edge of the rafter.
Now that the square has been lined up on the 30 degree mark however the angle drawn will be a 30 degree angle.
The pivot is a point at one end of the lip about which you can rotate the speed square to find angles.
Draw a line down the pivot point edge of the speed square on the exact same side that the 90 degree line was drawn.
At the corner of the square there is a pivot point.
Step 3 note the number on the common scale parallel with the 45 degree angle of the square.
Align the lip of the rafter angle square along the plumb line.