They also suggest the first coat of sem color coat aerosol is only dusted on.
How to dye vinyl door panels.
In your car cover the area with a thin layer of vinyl prep spray then wipe it off with a damp cloth.
Using the same two fingers begin to apply the dye to the very top of the door panel right at the window felt.
Vinyl fabric coating.
Formulated with a maximum adhesion promoter so there s no need for primer.
While it doesn t look too bad the dye was really scratched up and peeling in places.
This is the door panel i purchased at a swap meet.
Sem recommends applying your color while the sand free is still wet.
This door panel required 1 whole can of the cordovan brown color coat.
Here is a close up after shot.
This is after 30 40 minutes of stripping all the old dye off.
4 shake the spray can.
I did the same process on all the door panels.
Use a circular motion so that the dye is applied to all sides of the material.
I waited ten minutes between coats and applied about 4 coats.
Apply vinyl prep spray to your vinyl interior.