How To Drill A Hole Into Wall Tiles

It s easier to accurately mark the hole location.

How to drill a hole into wall tiles.

If the tile is. One simple trick that you can use to create some tension is to use masking tape over the area where you want to drill the hole. Attach the drill bit to your drill. Try to locate the hardware close to the center of the tile the edges crack more easily.

1 prepare the area before you drill through a tile. Use masking tape to mark the correct depth on your bit. Be sure to measure again after applying the masking tape so the hole is not misplaced then start your drill bit into the tape. Now put a piece of masking tape over your mark.

If you need your hole to be a particular depth e g if. Prepare the area before you drill through a tile. Put on safety goggles and a dust mask before you start drilling. Then measure and mark the tiles where you want your hole.

The secret to successful tile drilling is to keep your drill bits cool. Drilling can produce a lot of dust and debris. Mark where you will drill into the tile. Use a level to make sure everything is even.

Find out how to drill through a tiled wall properly this video from bunnings warehouse will show you some simple techniques to protect the tiles as you drill. Start to drill through tiles. You ve done all your prep you ve measured up and you ve got all the right gear it s. If you re going to hang a towel bar or anything that s going to bear weight it s a good idea to find the studs behind the tile and drill into them.

Examine the cleaned surface for damage. Creating the hole and adding a screw or anchor 1. Place your bit. Layout the wall for success first adhere masking tape to the wall in the area where you ll drill.

Put your safety goggles on. Change your drill bit to suite the substrate the tiles. Put a drop sheet down to protect your floor. 2 drill a hole through the tile.

Measure it again after placing the masking tape to ensure that you didn t misplace the hole. Clean the tile s surface. Begin by making an x over the tile in the spot to be drilled using masking tape. Seriously what s worse than a crooked shelf or towel bar.

Measure the area mark it with an x and place the masking tape. The tape gives the bit the necessary surface traction. Keep your bits cool. Instead use an abrasive.

An ordinary steel drill bit may fail to penetrate the tile or cause it to shatter.