How To Cut House Wrap Around Windows And Doors

For this opening i m going to cut what i call an upside down wine glass.

How to cut house wrap around windows and doors.

Start by nailing the corners in place under the house wrap at the sides and over the house wrap below photo 4. Install side flashing over the wrap. Write down the figures for each installation so you don t waste materials. Wrap first cut later.

The easiest way to apply house wrap is to go right over the window and door rough openings. Secure the wrap to the flange with tape or caulk. How to cut in a window with house wrap duration. Important they sliced the wrap above the window and installed the top piece over the window s nailing flange.

Measure the openings in the wall where the window or door will eventually be installed. Cut the tape using scissors to the. Preparing the sill. Cut a large x from one corner diagonally from one corner to the other.

Take care not to cut into the flashing itself if it has been constructed out of a flexible material. Start by setting the 1x6 on top of the side casings and marking it at the outside edge of each casing. Install head flashing and extend out 3 4 inch to each side. Then cut the center section to fit.

Pay attention to the raised ribs which provide a flat surface where the window frame rests. Installing exterior doors windows. Making a flap at the top where the diagonals have been cut will enable flashing to be placed behind the layer of wrap. Now fold the flaps to the inside and tack them down.

Then you have to come back and cut through in order to install the windws and doors. Tape the flap from step 2 over the flashing. Then cut the fillet 3 4 in. The house wrap is slippery material and using the wrong tape on the seams can lead to failure.

On both sides of the window or door trim the wrap close to the window or door flange. Cut out windows in an x shape. Cut the 1x6 to length. Nail the fillet to the bottom of the 1x6 to complete the head or and window casing assembly.

As with the window apply the wrap continuously over the door opening before the unit is set and utilizing the same or similar pattern for cutout. The flashing is easy to cut with tin snips. How to install house wrap window flashing.