We prefer double cut shears instead of single cut shears.
How to cut corrugated iron roofing sheets.
The double cut design leaves clean and smooth edges on both sides unlike the single cut shear and doesn t leave too much waste.
Want to cut iron lengthwise.
Brace the corrugated metal with your nondominant hand and start to cut.
Here s a better way.
Wear hearing and eye protection.
Paint or prime cut edges to prevent rust.
Angle grinder 1 x research source the fastest option.
Most panels come up to 32 feet 9 8 m in length.
Mark a cut line along the right and left sides and along the middle of the sheet using a.
Measure the length you need to cut starting at one end of the corrugated plastic roofing sheet.
You want a pair of straight cuts or left or right handed pair for cutting both straight and around corners.
Step 1 cut the panels to the desired length.
Circular saw 2 x research source slower than angle grinder but follow same step 2 pre drill holes on the ridges.
Brace the metal by applying pressure with your nondominant hand holding it at least 2 feet 0 61 m away from your saw.
Another efficient way to cut corrugated metal sheets is by using electric shears.
The best tin snips are good for cutting any edge of corrugated iron that is going to be seen as they are easy to control when cutting.
The cheapest way to cut metal roofing is with a pair of tin snips.
Sick of paying for expensive and smelly cutting disks.
Some panels have pre drilled holes.
Allow for a minimum of 18 inches 46 cm if you need to lap to complete the run.
If yours do not.
Corrugated metal roof panels.