The problem however is that oil or grease will eventually make the sticking lock worse.
How to clean a sticky door lock.
Resorting to spraying vegetable oil wd 40 sewing machine oil or similar products in the keyhole is a fairly common fix.
Start spraying the lubricant in short blasts.
Slide the doorknob off the.
Once you get all three of these perfectly clean and sprayed with dry lube you can reassemble.
Leave the lock in the door but only remove the cover and other parts to get in to clean it.
Once taken apart use gum out or a similar type of cleaner to clean the inside of the lock and all moving parts.
This is because the oil or grease provides an ideal attractant for dust particles and dirt which will start layering on top.
Start by using a little bit of lubricant and apply more if the lock still sticks.
Use the right product.
The way a professional would clean out the lock is to blow a small pinch of powdered graphite into it.
A thin wire can also be inserted.
Here s how to remove and clean the most common type of door lock.
When spraying the lock.
Remove the two screws that hold the lock faceplate on the edge of the door.
Get a screwdriver and remove the screws holding the lock on your door.
Move to the edge of the door.
Follow each spray shot by a resting period of about two seconds.
Next insert the key in the door lock and move it around repeatedly.
Steps to clean the lock.
Below are 3 tips to fix sticky locks.
Grasp the doorknob with one hand and turn it to retract the latch.
Just gently squeeze a very small amount of graphite powder into the keyhole and then use your key to slowly work the lubricant into the lock.
Insert the tip of your powdered graphite tube into the opening around the latch and inject a few.
Otherwise the fine black dust can get everywhere staining surfaces and creating a.
Spraying down the lock cylinder does nothing to lubricate between these two parts so you need to take them apart clean everything inside here and clean all the gunk off of here and then spray it with your dry lube.
Another way to clean out the lock is to rub a lead pencil over the edges of your key then insert the key and wiggle it.
With the door open use a phillips screwdriver to take out the two connecting screws that are located by the doorknob on.