A hammer drive anchor requires only a small pilot hole.
How to build a stud wall on concrete floor.
If this is the case drill through the curb and into the slab with a roto hammer every few feet.
Second can you say if it is a screeded over timber floor or concrete.
The one shown requires only a 1 4 inch hole.
It will make a difference and i m not going to jump to conclusions.
Fro your post i suspect the latter.
Your local building code may call for the wall to be anchored to the slab with threaded rods.
First ensure the existing wall to which the new one will attach at a 90 degree angle has a stud immediately behind.
How to frame garage walls over concrete diy guide with photos step 1.
You ll need a solid baseplate attached to the foundation unless you re just attaching thin studs to the concrete.
Space attachments every 12 inches using two at a time.
This is a short video on anchoring a wooden wall onto a concrete floor.
Build the wall frame.
Knowledge of the location might help including age of house and ground floor or above.
Snap chalk lines.
Mark the length of the new wall on both the adjoining wall and floor.
Drill the hole at least 1 4 inch deeper than the length of the lower portion and vacuum or blow out the hole.
How to frame a non load bearing interior wall on concrete.
Run a chalk snap line between the marks and snap the line against the slab to lay out the position of one of the wall s sides.
Determine the wall location.
Then fill the holes in the slab with hydraulic cement.
Drop in the anchor and hammer on the pin to expand the bottom of the shield against the wall of the hole.
Secure the frame to the wall.