You simply pull back on the emergency cord and it disengages.
How to attach cord to garage door.
Rotate the drum to wind the cable into the winding grooves.
The first key is that you have to open your garage door.
First you need you to make sure the garage door is open.
Trying to reengage your garage door opener with the door closed doesn t work.
You ll have to do this manually since it isn t attached to the.
Give your garage the strength and style it needs with a clopay garage door.
Pull the rope that s attached to your garage door opener.
Pulling back a second time does.
Diy garage door repair and save money.
Thread one end of the cord through the handle.
Attach the cables in the slots of the door bottom these slots are usually made for the door cables.
Get two c clamps and attach them to the door s track just beneath the roller that s.
Leave the locking pliers in place and repeat the tightening procedure on the other side.
Just pull the red cord straight down to disengage the door from the opener.
It will release the door opener.
Pull the emergency release cord toward the door.
Now you re ready to re attach the door in four easy steps.
Step 2 will allow you to freely move the garage door open and close.
If your garage door cable is at an angle or l.
This video will show you how to repair a mis aligned garage door cable.
Pull the cable as tight as possible before tightening the setscrews.
Screw cable brackets to the door to secure the weather stripping.
Next up is reattaching the gear to the track.
Once that s done you can move the.
Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums.
Do so sliding the end of the cable into the slots making sure that it rests properly at the track of the garage door.
2 tie a single overhand knot in.
When you disengage it it s easy and obvious.
Manually move the garage door and return to down position.
If the handle has a written warning on it thread the cord so that the warning is upright when the cord is connected.