Stick a small adhesive decorating clip to the walls in each place you want to attach a strand of lights.
How to attach christmas lights to a masonry wall.
Start at one end and apply hot glue along the side of the base of the light then press it firmly against the brick.
Start at one end and apply hot glue along the side of the base of the light then press it firmly against the brick.
Hold it for about 10 seconds which should be enough time for the glue to cool and the light to adhere to the brick surface.
If you prefer having the lights stick out from the wall instead place a dot of glue under the base of each socket.
The bulbs will be perpendicular to the wall once you finish hanging them.
To secure a vertical stretch of lights going straight up or down the wall face the clips in.
Lay out your string of lights to ensure you have enough length to work with.
Spread a thin layer of glue on the wet part of the brick more is less in this case press and hold the.
You ll need yellow wall plugs a drill with 5mm masonry bit and a dustpan brush set the drill to the hammer setting.
Slide the coated wire portion of the light strand through a hook in the clip to.
Clean the bricks with a rag brush or broom to get all dirt and debris off the surface of the bricks wet a sponge and wipe across the surface of the brick.
Masonry fasteners and anchors are permanently placed into concrete brick and stucco but are complete overkill for hanging christmas lights.
They can damage walls and interior surfaces plus.
To use a clip just snap it over the brick vertically in the location where you want it to hold the light string.
Apply firm and steady pressure to your drill making sure you re at right angles to the wall s surface.