How To Attach Bathroom Sink To Wall

If the holes are not completely lining up or you want a more.

How to attach bathroom sink to wall.

Drill pilot holes into the wall at the marked locations. Two on the rear against the wall and one on each side. Use the template that comes with the sink to mark the. Set the sink on top of the pedestal then slide the sink close enough to the wall so you can insert the winged toggles into the mounting holes in the wall.

Remove the entire trap if necessary. Prepare the faucet drain and pop up. Installing a bathroom sink in a vanity is made easier by the fact that the supply lines and the drain all remain hidden within a cabinet. If the cabinet has a back you ll need to measure and cut three holes for the two supply lines and the drain.

Locate the large nut that connects the sink to the drain and disconnect it. Have a small bucket ready to catch any water. Use your hands or locking pliers to unscrew the nut. Ideally i would like to mount the sink using only the two rear tabs bolted to the wall.

This metal or plastic nut will be located either in the wall or the floor. Mount the sink to the wall. If the cabinet has no back simply attach it to the wall so it encloses the plumbing. Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines.

Install the sink if your sink includes a mounting plate you can use that for a template to drill your pilot holes. Follow manufacturer s directions for the size and depth of. If not turn off the water at the main valve. Use plumber s putty as you attach the.

Measure and mark the location of the sink on the wall again. Lift the sink slightly while tightening the nuts with a wrench. Lift the back edge of the sink onto the bracket. Verify the toggled wings open once you.

Check the level again before trimming the shims with a utility knife. If there are large gaps at the wall or floor attach quarter round moulding along the wall or floor edge. Be sure to use a masonry. Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers.

The pockets are not deep enough for the tabs on my sink the holes do not align etc. Attach the sink 1. For sinks that do not attach with a bracket ask an assistant to hold the sink at the wall so the upper holes at the rear underside of the sink. Remove the current sink by sliding the edge of a putty knife around the perimeter of the bathroom sink loosening any caulk that connects it.

Attach the vanity to the wall using 3 inch drywall screws. Drill your pilot holes for the lag screws which should be included with your wall mount sink. Then turn on the faucet. Loosen the slip nut at the top of the p trap.