To use it load a special gun nail and a 22 caliber gun shell into the barrel.
How to anchor a wooden wall on concrete.
Framing a wall on concrete slab floors is different than wood.
Press the nose against the workpiece pull the trigger and the shell will drive the fastener directly into the concrete.
The one shown requires only a 1 4 inch hole.
Step 2 install bolt align the hole in the wood with the hole in the concrete and insert the anchor bolt through the holes.
Mark where you will drill in both with a permanent marker.
Using hammer set concrete fasteners 1.
Personally l don t pre drill.
First of all position your timber in place and pre drill if necessary the hole in the timber where you want the concrete anchor to go.
Figure 2 l concrete foundation anchor bolt.
Drill a hole into the concrete approximately 1 4 inch 0 64 cm deeper than your.
Learn how to frame a wall and set it on anchor bolts.
Predrill a hole in the concrete.
We also show you how to frame a door ope.
Drop in the anchor and hammer on the pin to expand the bottom of the shield against the wall of the hole.
The steps to attach timber to concrete using masonry anchors are as follows.
Drill the hole at least 1 4 inch deeper than the length of the lower portion and vacuum or blow out the hole.
Drill the holes deep enough into the concrete so that the tops of the sleeves will be flush with the surface.
The spots you mark.
Drill a hole.
Align the concrete with the wood block.
The fastest and easiest way to attach most wood parts to concrete is to use a powder actuated gun.
When pouring the concrete pad insert l concrete foundation bolts as shown in figure 2 into the concrete in the correct position the center of the bottom plate of the stud wall before inserting the concrete anchor into the concrete apply a grease or vaseline.
You want the depth of the hole to be inch more than the length of the anchor bolt.
Predrill a hole into the wood and concrete that is large enough in diameter for the anchor bolt to fit.
Use a hammer drill and a masonry bit to drill two 1 2 inch holes through the kick plate into the concrete to insert 1 2 inch metal sleeve anchors.