Use some caulk on the bottom of the threshold until it s completely covered.
How to adjust upvc french door locks.
Repeat step 2 with the middle hinge.
Insert the allen key into the hole on the main part of the hinge.
Check the distance between the french doors leaf and frame with a tape measure or yard stick.
Use the type of screwdriver that matches the heads on the hinge screws.
Repeat the above step with the middle hinge.
Then remove all the screws holding the door threshold in place before removing it.
In order to adjust it you have to turn the corner bearing adjusting screw.
Locate the hole at the bottom of the hinge.
Check the level of the door use a spirit level on the top of the door.
Open both of the french doors to expose the screws holding the hinges in place.
Over time the screws on your hinges may come loose and cause your doors to sag.
Don t forget to count the number of turns.
This will help you adjust the height.
After each adjustment.
Look at the corners of the door are the mitres lined up with the mitres of the door frame.
Then place the threshold back into the opening and screw it back in.
Making sure to count how many turns you make turn.
Check the gap between the door and the frame open the door slightly and at the lock.
Begin by removing the plastic covering on the main part of the hinge.
Your door may have 1 2 or 3 slots per hinge in order to make vertical horizontal and depth adjustments.
Put an allen key into the hole and turn it until the door raises slightly.
This method of adjustment works best if the bottom of.
Tighten the screws in the hinges at the edges of the doors and at the faces.
Open your doors fully and use a prop to keep them open.
Open both doors fully and stabilize each with a doorstop.
Turn it clockwise to lift the leaf and anticlockwise to lower it fig.
Remove the plastic covers from the corner bearings lower hinge.
Tighten all of the screws in each hinge with a screwdriver.
Be sure to.
Instead follow the guide below.
How to check if your door is out of alignment.