Adjusting garage door springs is a common repair.
How to adjust garage door sprimgs.
Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension.
Add more concrete to the floor.
Retest the door.
When garage doors won t close all of the way or they close unevenly spring adjustment may be called for.
The cone is on the torsion spring on the left side away from the.
If the door was closing too quickly move the spring to the next higher hole on the bracket.
This can make the other parts of the garage door last a much longer time.
Adjust the springs on both sides of the door the same way.
How to adjust a torsion spring garage door step 1.
If you have a wooden garage door then you can trim the door down to make it fit properly.
Look for a reddish cone on the torsion spring.
To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller.
If it was opening too quickly move it to the next lower hole.
Troubleshooting garage door springs.
This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.
Adjusting garage door extension.
Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.
Use a metal rod to stick in the first notch of the cone.
Adjust the spring into the proper position and make sure your garage door closes all of the way.
If you don t have a wooden garage door you may be looking at a garage door replacement.
One end of the spring is connected to the garage door track or frame.
Garage door springs are used to offset the weight of the door.
How to safely adjust your garage door spring.
Once the spring is free of tension remove from its track hanger.
You must release the tension on the garage door springs before attempting adjustment or replacement.
Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out.
The other is attached to a pulley connected to the cable.