If your paneling is tongue and groove place the groove.
How do you install plaster panels on wall.
For best results the plaster should be applied while the pva coat is tacky but not completely dry.
Press each panel firmly into place.
Apply adhesive step 7.
Cut each sheet 1 4 inch shorter than the distance from the floor to the ceiling.
Then pull the panel away from the wall for about a minute to allow the glue to develop tackiness.
Position the panel on the wall leaving a 1 4 inch space at the bottom and drive the four nails partway into the wall.
Place a wood panel against the wall in a corner with the base resting on top of the baseboard.
Press all over the surface to assure glue transfer to the wall.
Roll or brush the pva over the entire wall aiming for total coverage.
Use masonry screws and a drill to apply one screw every 18 inches on top of the stud.
Cut openings step 6.
If the walls have no studs apply a panel adhesive to the back of the beadboard and to the wall.
The typical method of installation is to press the panel to the wall using your hand or a towel.
Trim to fit step 5.
Masonry screws work best on plaster regular panel nails will not be able to penetrate the plaster.
Combine one part pva glue with four parts water in a disposable paint tray and mix thoroughly.
Allow a 1 8 inch expansion gap in the corner.
Apply adhesive to the framing in a wavy pattern.