Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.
How do you adjust spring tension on a garage door.
Lift the door and check the balance.
Once the spring is free of tension remove from its track hanger.
Take note of the notches and screws that hold the torsion spring in place.
Next get hold of one of the tension rods and push it into the first notch.
If you need to increase the spring tension hook the spring onto a lower hole on the track hanger.
Reattach the hook at the next link up to loosen the.
To decrease tension move the hook to a higher hole.
Once the screws are loosened place the second metal rod into an opposite notch on the cone and turn both rods to the right or to the left depending on whether you are tightening or loosening the tension.
Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension.
Then insert another rod into a hole below the rod you already inserted.
Lower the door and use 2 metal rods to adjust the tension in the spring.
Pull downward on the spring and reattach the hook at the lower end of the spring at the next link down the chain to increase the spring tension.
Get another metal rod of the same size.
Adjust the springs on both sides of the door the same way.
If the door was closing too quickly move the spring to the next higher hole on the bracket.
Then add or release tension until you get the proper close rate photo 2.
Start by removing the locking pin photo 1.
If the door lifts by itself or if it is hard to pull down you will need to unwind the springs.
If it was opening too quickly move it to the next lower hole.
You must release the tension on the garage door springs before attempting adjustment or replacement.
This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.
If the self closing door to your garage isn t closing hard enough to latch properly or the door slams shut you can adjust the spring hinge tension with a hex wrench and pliers.
You can adjust the spring tension on a wayne dalton torsion garage door with a few simple tools.
Locate a reddish color cone around the spring.
If the door is hard to lift or if it is too easy to pull down you will need to wind the springs.