How Do I Tightn The Freezer Door Handle Kenmore Fridge

If your frigidaire has a door handle that is broken or loose tighten or replace it to ensure that the refrigerator and freezer doors are easy to open.

How do i tightn the freezer door handle kenmore fridge.

Often adjusting the feet so that the fridge is level makes tightening the door unnecessary. Unscrew these set screws and pull the handle off. If the handles are not installed properly check the following. You have to adjust the bottom of the fridge to ensure the entire unit is level.

Download a copy of the installation instructions. I called sears who have no goodwill and are sending out an engineer at a cost of 69 00 to diagnose the problem. The bottom of the handle is secured by a locking tab rather than a screw. Kenmore elite s s refrigerator door handle loose i have the same problem.

If the door handle on your freezer or refrigerator are loose you simply need to open the fridge or freezer door and tighten the small allen screws on the inner door handle. Using your small flat screwdriver gently work your way around the plug prying the plug up and place it in the hole where you removed the hinge plate. Open the fridge door and unscrew the top of the handle. Most handles require a 3 32 or 1 8 allen wrench to tighten.

I hope i have earned a 5 star rating. Step 1 insert an allen wrench into the allen slot on the top inside portion of the door handle. Then rotate the handle counter clockwise past the corner guard. Sometimes the allen screw may be tight but the part the screw installs onto might be loose so taking the door handle off to check is a good idea.

Then tighten the mounting bolts down going into the front of the freezer push the handle in place and then tighten the set screws down. The top connection of the handle to the door got loose and now has come off completely. If the door on your kenmore refrigerator is not properly aligned it may not close properly causing serious problems with cooling efficiency and effectiveness. Gently lower the fridge so all four feet are firmly on the ground and then test the door again.

Some bottom freezer handles are not factory installed. To tighten the handle there are some set screws below the handle on the right and left side. On the handle side to the outer edge of the handle you will see a small vinyl or plastic plug top of freezer door. Typical the machine is just out of warranty by only 2 months.

4 open the freezer door and lift the freezer door off the pivot pin. There are two screws at the top of the door and once they are removed keep them on hand to install the new handle. Turn the wrench clockwise to tighten the handle if it is loose.