How Do I Align The Garage Door Sensors

They are very.

How do i align the garage door sensors.

Tie a string long enough to span the width of the garage door around the bracket on one side so that the string will line up with the sensor lens. How to adjust a photo eye on a garage door. Run the string across the garage doorway and tie it to the other sensor. The amber light on the sending sensor will glow regardless of alignment or obstruction.

Make sure that the string is taut between the two sensors. If the lights on the sensors are lit it probably means that there is another reason that your garage door isn t closing. On most brands of garage door sensors the led light on each sensor will not light up unless the sensors are aligned. The best way to do this is to trip the.

You now need to check that the string is. Loosen the screws that mount each of your garage door sensors. They should be at each side of the garage door near the ground. The lights on both the sending and receiving sensors will glow steadily when the wiring connections and alignment are correct.

Evaluate the problem you are having with the garage door. Slide each garage door sensor downward so it is as. Modern day garage door safety sensors are usually led and if the sensors are aligned correctly with the two beams connecting they should light up green. To realign them adjust the sensor that seems misaligned and wait for the led lights to light up.

Do not handle them more than necessary or you might well put them out of alignment. Firstly you ll need to cut off the power to your garage door properly. Don t take them all the way out. You ll find this in your home s breaker box.

Obtain a string to check the alignment of the sensors. Tie a string to one of the sensors so if pulled across the garage doorway it will run across the center of the sensor. If the garage door goes up but does not close or only partially closes then reopens. Check to make sure nothing stored near the garage doorway is obstructing the sensors.

Turn off the power to your sensors by tripping the fuse for your garage. Pull the string taut and tie to the other bracket in the same position. Take a clean cloth and very gently wipe them in case they have accumulated dust or residue of some sort.